Terex Genie GS-1330m Service And Repair Manual page 145

August 2021
77 Attach a lifting strap from an overhead
supporting device to the number 3 inner arm
(index #28). Raise the number 3 inner arm
and remove the 4 x 4 x 48 inch / 10 cm x
10 cm x 1.2 m block from the link stack.
78 Lower the number 3 inner arm (index #28)
and remove the lifting strap.
79 Attach a lifting strap from an overhead
supporting device to the lug of the rod end of
the lower lift cylinder.
80 Remove the retaining fasteners from the
lower lift cylinder rod end pivot pin (index 11).
81 Use a soft metal drift to remove the lower lift
cylinder rod end pivot pin (index 11) from the
machine.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
82 Place a 4 x 4 x 10 inch / 10 x 10 x 25 cm
block onto the number 1 inner arm cylinder
plate (index #16).
83 Lower the cylinder onto the block.
Bodily injury hazard. Keep
hands clear of moving parts
when lowering the cylinder.
84 Attach a lifting strap from an overhead
supporting device to the number 3 inner arm
(index #28). Raise the arm to a vertical
position.
85 Remove the retaining fasteners from the
number 3 pivot pin at the steer end of the
machine (index #12).
86 Use a soft metal drift to remove the number
3 pivot pin (index #12) from the steer end of
the machine. Remove the number 3 inner arm
(index #28) from the machine.
Crushing hazard. The number
3 inner arm (index #28) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
Part No. 1309020GT
87 Attach a lifting strap from an overhead
88 Remove the retaining fasteners from the
89 Place a rod through the number 2 center pivot
90 Remove the retaining fasteners from the
91 Use a soft metal drift to remove the number
92 Attach a lifting strap from an overhead
93 Remove the retaining fasteners from the
94 Place a rod through the number 2 center pivot
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
supporting device to the number 2 outer arm
at the ground control side (index #31).
number 2 center pivot pin (index #13) at the
ground control side.
pin at the ground control side (index #13) and
twist to remove the pin.
number 2 pivot pin (index #32) at the non-
steer end.
2 pivot pin (index #32) from the non-steer end
of the machine. Remove the number 2 outer
arm at the ground control side (index #31)
from the machine.
Crushing hazard. The number
2 outer arm at the ground control
side (index #31) may become
unbalanced and fall if not
properly supported when the
pivot pin is removed.
supporting device to the number 2 outer arm
at the battery side (index #31).
number 2 center pivot pin (index #13) at the
battery side.
pin at the battery side (index #13) and twist to
remove the pin.
Crushing hazard. The number
2 outer arm (index #31) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
131