Terex Genie GS-1330m Service And Repair Manual page 52

Service and Repair Manual
Ground Controls
22 Press and hold the Enter button to start
calibration.
Result: An audible alarm will sound when
calibration is complete.
Note: The machine will not calibrate if it is on a
slope of one degree or greater.
Note: If the level sensor has been replaced,
continue with step 23. If the level sensor was not
replaced skip to step 26.
23 Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
24 Return the safety arm to the stowed position.
25 Lower the platform to the stowed position.
26 Place a digital level on the ground control side
of the drive chassis. Zero out the digital level.
27 GS-1330m:
Drive the steer end of the machine up a ramp
until it is just under 2.5°.
All other models:
Drive the steer end of the machine up a ramp
until it is just under 3°
38
28 Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
29 Lower the platform to the stowed position.
30 GS-1330m:
31 Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
32 Lower the platform to the stowed position.
33 GS-1330m:
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Result: No audible alarm is heard.
Result: The platform stops, an audible alarm
is heard and Fault LL is displayed. Repeat
this procedure starting at step 15 on a firm
level surface.
Drive the steer end of the machine up a ramp
until it is just above 2.5°.
All other models:
Drive the steer end of the machine up a ramp
until it is just above 3°.
Result: The platform should stop, an alarm
should sound and fault code LL appears in
the diagnostic display.
Result: The platform does not stop or the level
sensor alarm does not sound. Repeat this
procedure starting at step 15 on a firm level
surface.
Drive the non-steer end of the machine up a
ramp until it is just under 2.5°.
All other models:
Drive the non-steer end of the machine up a
ramp until it is just under 3°.
August 2021
Part No. 1309020GT