Terex Genie GS-1330m Service And Repair Manual page 173

August 2021
Full Load Calibration: Part 1
1 Fully charge the batteries and check the
hydraulic fluid level.
Note: The hydraulic fluid level must be between
the FULL and ADD marks on the hydraulic tank.
2 Apply a thin layer of dry film lubricant to the
area of the chassis where the scissor arm
wear pads make contact.
3 Chock both sides of the wheels at the steer
end of the machine.
4 Place the maximum rated load in the platform.
Secure the load to the platform.
GS-1330m, GS-1432m, GS-1930,
GS-1932, GS-1932 XH, GS-1932m,
GS-1932m Lite, GS-1932m XH, GS-
2632, GS-3232
GS-1530, GS-1532
GS-2032
Note: In the event of frequent nuisance trips
occurring after calibrating a GS-3232 machine, it is
recommended to recalibrate the machine, full load
and no load, with 250 kg of weight in the platform.
GS-2046
GS-2646, GS-2646 XH
GS-3246, GS-3246 XH
GS-4046, GS-4655
5 Turn the key switch to ground controls.
6 At the ground controls, press and hold the
Menu Up and Menu Down buttons.
7 While pressing both buttons down, pull out the
red Emergency Stop Button.
Part No. 1309020GT
8
9
10 Press the Menu Up or Menu Down buttons to
11 Press the Menu Up or Menu Down buttons to
12 Confirm the Platform Overload Calibrate
500 lbs / 227 kg
13 Press the Menu Up or Menu Down buttons to
14 Press the Enter button to confirm rated load is
600 lbs / 272 kg
800 lbs / 363 kg
15 At the ground controls, press and hold the
16 GS-4046: Press and hold the Menu Enter
1200 lbs / 544 kg
1000 lbs / 454 kg
700 lbs / 317 kg
770 lbs / 350 kg
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
Release the Menu Up and Menu Down
buttons after the ground controller powers up.
Press the Menu Up or Menu Down buttons to
scroll to, Select Option. Press the Enter
button.
scroll to Platform Overload. Press the Enter
button.
scroll to Platform Overload Calibrate. Press
the Enter button.
selection by pressing the Enter button again.
select Full Load calibration. Press the Enter
button.
in the platform.
Function Enable and Platform Up buttons until
the platform reaches maximum height.
button to determine the maximum height. The
machine will lower for 1.2 seconds and then
raise in 1.2 second durations, until maximum
height is reached. When the platform reaches
the maximum height, a message will appear
on the LCD screen to release the Menu Enter
button.
Note: Do not release the Menu Enter button
before the message appears on the LCD
screen.
All other models: When the platform reaches
maximum height, press the ground controls
Enter button. Allow the ground controls to
gather data.
159