Terex Genie GS-1330m Service And Repair Manual page 151

August 2021
38 Using an overhead supporting device attach a
4 hook sling chain to the ends of the number
5 inner arm. Make the chains tight but do not
apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not
properly supported when
removed from the machine.
39 Remove the retaining fasteners from the
number 5 pivot pins.
Note: Do not remove the external snap ring.
40 Using a soft metal drift, remove the pivot pins
and set aside.
41 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
42 Using an overhead supporting device attach a
4 hook sling chain to the ends of the number
4 inner arm. Make the chains tight but do not
apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not
properly supported when
removed from the machine.
43 Remove the retaining fasteners from the
number 4 pivot pins.
Note: Do not remove the external snap ring.
44 Using a soft metal drift, remove the pivot pins
and set aside.
45 Carefully lift the linkage assembly off of the
machine and place it on a structure capable of
supporting it.
46 Tag and disconnect the harness from the
upper lift cylinder valve block.
Part No. 1309020GT
47 Tag and disconnect the hydraulic hoses from
48 Remove the cables and hoses from the
49 Using a suitable supporting device remove
50 Using a suitable supporting device, attach a
51 Remove the lower cylinder rod end pivot pin
52 Using a soft metal drift, remove the pivot pin.
53 Lower the lift cylinder and remove the strap.
54 Using an overhead supporting device attach a
55 Remove the retaining fasteners from the
Note: Do not remove the external snap ring.
56 Using a soft metal drift, remove the pivot pins
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
the upper lift cylinder. Plug the hoses and cap
the fittings.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
linkage assembly.
Component damage hazard.
Cables and hoses can be
damaged if they are kinked or
pinched.
the retaining fasteners from the upper lift
cylinder. Remove the cylinder.
strap to the rod end of the lower lift cylinder.
Do not apply pressure.
retaining fasteners.
4 hook sling chain to the ends of the number
3 inner arm. Make the chains tight but do not
apply lifting pressure.
Crushing hazard. The linkage
assembly could become
unbalanced and fall if not
properly supported when
removed from the machine.
number 3 pivot pins.
and set aside.
137