Lift Cylinder - Terex Genie GS-1330m Service And Repair Manual

August 2021
19 Remove the fasteners securing the large
platform height bracket to the number 1 inner
arm pivot bracket.
20 Remove the large platform height sensor
bracket from the number 1 inner arm pivot
bracket.
Tip-over hazard. Failure to install
the fasteners securing the large
platform height sensor bracket
and number 1 inner arm pivot
bracket to the chassis, could
result in the machine tipping
over, causing death or serious
injury.
Part No. 1309020GT
9-13
Lift Cylinders
How to Remove the Lift Cylinder
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
GS-1330m, GS-1432m, GS-1530, GS-1532,
GS-1930, GS-1932, GS-1932 XH, GS-
1932m, GS-1932m Lite, GS-1932m XH
1
2
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Turn the key switch to ground controls and
pull out the red Emergency Stop button to the
on position at both ground and platform
controls.
Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
145