Pressure Transducer - Terex Genie GS-1330m Service And Repair Manual

August 2021
9-14

Pressure Transducer

How to Remove the Pressure
Transducer
Note: Calibrating the platform overload system is
not required if the pressure transducer is the only
component replaced on the machine lift structure.
In the event of frequent nuisance trips occurring
after a pressure transducer is replaced, a no load
calibration is recommended. Refer to Repair
Procedure, How to Calibrate the Platform
Overload System.
1 Turn the key switch to ground controls and
pull out the red Emergency Stop button to the
on position at both ground and platform
controls.
2 GS-4655: Raise the platform approximately
13 feet / 4 m.
All other models: Raise the platform 7 to
9 feet / 2,1 to 2,8 m.
3 GS-1432m, GS-1932m, GS-1932m Lite, GS-
1932m XH: Raise the safety arm from the
drive chassis to a vertical position.
All other models Lift the safety arm, move it to
the center of the scissor arm and rotate down
to a vertical position.
4 Lower the platform onto the safety arm.
5 At the ground controls, turn the key switch to
the off position and push in the red
Emergency Stop button to the off position.
6 Disconnect the battery pack from the
machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
7 Pull the manual lowering cable and hold for
3 seconds.
Part No. 1309020GT
8
9
10 Connect the battery pack to the machine.
11 Turn the key switch to ground controls.
12 Press and hold the ground control scroll up
13 Pull out the red Emergency Stop button to the
14 Using the ground control menu buttons,
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
15 Raise the platform and rotate the safety arm
16 Fully lower the platform to the stowed
Torque specifications
Pressure transducer
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
Tag and disconnect the three-pin connector
from the pressure transducer harness.
Slowly loosen the pressure transducer from
the lift cylinder and remove. Discard the
pressure transducer.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
and scroll down buttons.
on position at the ground controls.
navigate to Service Override Mode. Select
Service Override Mode.
to the stowed position.
position.
27 ft-lbs
37 Nm
157