Restoring Shift Coordinates; Editing The Shift Coordinate Range - Yamaha RCX141 User Manual

n
NOTE
• "n" is a shift coordinate number.
[Example]
SP1 ...... Plus side work area of
shift coordinate S1
SM 2 .... Minus side work area of
shift coordinate S2
• When the plus and minus sides on
an axis (x, y, z, r) are both at 0.00,
the work area on that axis is not
be restricted.

11.5.1.1 Restoring shift coordinates

[Procedure]
During shift coordinate data editing, pressing the
data input and restores the preceding data.
This function is enabled only on lines that are not yet complete.
11.5.2

Editing the shift coordinate range

By setting the shift coordinate range, the robot operating area can be restricted to the
desired range on each shift coordinate. Moreover, setting the soft limit parameters allows
you to specify the robot work area more precisely.
Shift coordinate range data format
• Plus side
SP n= ±###.## ±###.##
dPX (mm) dPY (mm)
• Minus side
SMn= ±###.## ±###.##
dMX (mm) dMY (mm) dMZ (mm)
(n=0 to 9)
Fig. 4-11-55 Shift coordinate range
X
dPR
dMR
X' Y
To edit a shift coordinate range, use the procedure below.
[Procedure]
1) In "MANUAL>SHIFT" mode, use the cursor (↑/↓) keys to select the shift coordi-
nate number you want to edit.
11. "MANUAL" mode
(UNDO) key reverses the last
F 1
±###.## ±###.##
dPZ (mm) dPR (degrees)
±###.## ±###.##
dMR (degrees)
–
dMZ
Z'
dPZ
+
Y'
4
109
4-