Yamaha RCX141 User Manual page 237

c
CAUTION
When making the Ethernet settings to
use TELNET, you will need to set any
other parameters than those shown
on the right. For more details, see the
Ethernet manual.
12.1.4.3 Setting the network parameters
When using Ethernet, you set four parameters including the parameter to enable or disable
the Ethernet board.
Parameter
1. Board condition
2.
IP address
3. Subnet mask
4. Gateway
[Procedure]
Fig. 4-12-51
SYSTEM>PARAM>OP.BRD
1.E_Net
2.
3.
4.
SELECT
1) In "SYSTEM>PARAM>OP. BRD" mode, select "E_Net" with the cursor keys and
press the (SELECT) key.
F 1
Fig. 4-12-52
SYSTEM>PARAM>OP.BRD>SELECT
1.board condition
2.IP address
3.Subnet mask
4.gateway
5.port No
EDIT JUMP
2) Select the parameter with the cursor (↑/↓) keys.
Fig. 4-12-53
SYSTEM>PARAM>OP.BRD>SELECT
1.board condition
2.IP address
3.Subnet mask
4.gateway
5.port No
EDIT JUMP
12. "SYSTEM" mode
Meaning
Enables or disables the Ethernet board. When set to "VALID"
the Ethernet can be used. When set to "INVALID" Ethernet
cannot be used.
Sets the IP address.
Sets the subnet mask.
Sets the gateway.
V8.30
V8.30
VALID
192.168.
255.255.255. 0
192.168.
23
V8.30
VALID
192.168.
255.255.255. 0
192.168.
23
VALID
0. 2
0. 1
0. 2
0. 1
179
4-
4