Driven Clutch Slider Inspection - Polaris RZR 900 2017 Service Manual

DRIVEN CLUTCH SLIDER INSPECTION

The square sliders can be inspected with the driven
clutch installed on the vehicle.
Using a feeler gauge, measure the distance between the
slider and the stationary sheave at the widest point
the measurement is over the service limit, the sliders or
driven clutch will need to be replaced. Also measure the
w
width of the slider block . Replace the sliders if they are
smaller than the service limit.
MEASUREMENT
Slider to Sheave Clearance
Service Limit: 0.175" (4.5 mm)
Slider Width
Service Limit: 0.975" (24.8 mm)
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
DRIVEN CLUTCH DISASSEMBLY
1. Remove driven clutch from the transmission input
2. It is important to mark the position of the helix cover,
q
. If
3. Place the driven clutch (helix side up) into the
q
:
w
:
shaft.
sheaves and spider with a tape or grease marker (as
shown) before disassembly. Some components will
have X's on the components for alignment reference.
This helps with clutch assembly and maintains clutch
balance.
Universal Clutch Compressor.
Universal Clutch Compressor: PU-50518-A
PVT SYSTEM
6
6.25