Installing The Driver When Windows 2000 Or Windows Server 2003 Is Already Installed - Adaptec 29320A-R Manual

Installing the Driver When Windows 2000 or Windows Server
2003 is Already Installed
To update or install the a320raid.sys driver if Windows 2000/2003
is already installed:
1 Create a Windows driver disk. See
Floppy Disks
2 Start Windows 2000/2003.
Windows 2000/2003 will automatically discover the new
hardware and start the Found New Hardware Wizard to guide
you through the device driver installation.
3 At the Welcome to the Found New Hardware Wizard window,
select Next.
4 On the Install Hardware Device Drivers screen, select Display a
list of the known drivers for this device, and click Next.
5 On Select a Device Drivers screen, select the Have Disk button.
You will be prompted to insert the manufacturer supplied disk.
Insert the Windows driver disk you created in your floppy disk
drive and enter the following path:
a:\win32
Click the OK button.
6 Select the appropriate HostRAID driver for your controller from
the list (for example: Adaptec ASC 39320A HostRAID Driver),
then click the Next button.
7 On the Update Driver Warning window, click Yes to continue
the installation.
8 Click the Next button again to confirm the installation of the
driver. You may be prompted with this warning message:
"The software you are about to install does not contain a
Microsoft Digital Signature ..."
Ignore the warning and click Yes to continue the installation.
9 When the driver is copied on the hard disk drive, click Finish.
10 You will be prompted to restart the computer. Select Yes.
Installing the HostRAID Driver for Windows 2000, 2003, and XP
for more information.
Appendix D, Creating Driver
5-3