Boot The New Kernel - Adaptec 29320A-R Manual

Installing the SCSI Driver for UnixWare, OpenServer, and Open Unix
2 When the kernel has been built, type the following and press
Enter after each line (0 in -g0 is zero, not the letter O):
cd /etc/conf/cf.d
cp unix /stand/unix
cd /
shutdown -g0
3 Type y and press Enter when the computer asks if you really
want to shut down.
The UnixWare/Open Unix kernel is now ready for host adapter
operation.

Boot the New Kernel

To reboot the computer with the new kernel:
1 Follow the on-screen instructions (usually by pressing Enter) to
reboot your computer.
2 Check the bootup messages to verify that all your installed SCSI
devices are listed.
If some or all of your installed SCSI devices do not appear at
this time, your SCSI cables may be loose, or the SCSI device
setup may not be complete. If so, go back and correct any
problems before proceeding.
3 Wait for UnixWare/Open Unix to complete bootup with the
new kernel.
Refer to Troubleshooting on page 11-11
if panic (UnixWare/Open Unix ) messages appear during
bootup.
The updated driver for UnixWare/Open Unix should now be
ready to use.
System Is Down
should appear on the screen.
if the computer crashes or
11-7