Adaptec 29320A-R Manual page 175

Migrating From Adaptec
Ultra320 SCSI to HostRAID
In this Appendix...
Migrating With Windows 2000
Migrating With Windows XP
Migrating With Windows NT 4.0
After installing the Adaptec Ultra320 SCSI drivers, you may want
to enable HostRAID and use the RAID functionality of your
Adaptec SCSI Card. To install your HostRAID drivers and use
HostRAID on your Adaptec SCSI Card, refer to the following
sections of this appendix. For information on how to migrate from
HostRAID to standalone SCSI, see
HostRAID to Adaptec Ultra320
!
Caution: Adaptec recommends that you back up all of your
data before migrating from Ultra320 SCSI to HostRAID.
Note: The migration from Ultra320 SCSI to HostRAID is
supported in Windows 2000, XP, and NT 4.0 only.
Appendix F, Migrating from
SCSI.
E
E-2
E-5
E-7
E-1