Completing The Hostraid Driver Installation - Adaptec 29320A-R Manual

Adaptec Ultra320 SCSI Cards User's Guide

Completing the HostRAID Driver Installation

After you have installed the HostRAID driver and enabled
HostRAID support, you need to complete the installation so that
the Windows operating system can detect the new enabled driver
hardware.
To complete your HostRAID driver installation, follow these steps:
1 Restart Windows 2000.
Windows 2000 will detect the newly enabled HostRAID
support and will prompt you for the HostRAID driver.
2 At the Welcome to the Found New Hardware Wizard window,
select Next.
3 At the Install Hardware Device Drivers window, select Search
for a suitable driver for my device, then click Next.
4 At the Locate Driver Files window, click Next .
5 Click Next again. You may be prompted with this warning
message:
"The software you are about to install does not contain a Microsoft
digital signature..."
Ignore the warning and click Yes to continue.
6 Insert the Adaptec Installation CD into the CD-ROM drive
when prompted, then click OK.
7 When the driver is copied on the hard disk drive, click Finish.
8 You will be prompted to restart the computer. Select Yes.
Note: To migrate the nonboot channel from SCSI to HostRAID,
follow the instructions for migrating from a boot channel for
your other channel.
E-4