Installation - Adaptec 29320A-R Manual

Adaptec Ultra320 SCSI Cards User's Guide
8 Repeat Steps 4 through 7 if there is another array. You will also
need to delete any spares.
9 Once all the arrays and spares have been deleted, press Esc to
go back to the SCSISelect menu.
10 Use the arrow keys to select Configure/View SCSI Controller
and press Enter.
11 From the Configuration menu, select HostRAID and press
Enter.
12 From the HostRAID Pop-up menu, select Disabled.
13 Press Esc, save change, then exit.
Completing the Adaptec Ultra320 SCSI Driver Installation
After you have installed the Adaptec Ultra320 SCSI driver and
disabled HostRAID support, you need to complete the installation
so that the Windows operating system can detect the new driver
hardware.
To complete your Adaptec Ultra320 SCSI driver installation, follow
these steps:
1 Restart Windows 2000.
Windows 2000 will automatically discover the new hardware
and will prompt you for the Adaptec Ultra320 SCSI Card CD.
2 You may be prompted with this warning message:
"The software you are about to install does not contain a Microsoft
Digital Signature..."
Ignore the warning and click Yes to continue.
3 Insert the Adaptec Installation CD into the CD-ROM drive
when prompted, click on the path
(where : is the CD-ROM drive letter), then click OK.
D
F-4
D:\drivers\windows\win32bit