Creating Raid 10 Arrays; Adding A Spare Drive - Adaptec 29320A-R Manual

3 After entering your options, if a partition exists on any of the
selected drives, you will get a message that the partition will be
deleted. Assign a RAID name by entering up to 15 alphabetic or
numeric characters, then press Enter. The following message
appears:
Do you want to make this array bootable?
4 Select Yes if you want to make the array bootable. The following
message appears:
Create Array?
5 Select Yes. The following message appears:
Are you sure?
6 Select Yes and press Enter to create a RAID 1 array. If you select
No, the RAID creation will terminate and you will return to the
Main menu.
After your array is created, the progress bar will appear
showing the percentage completed in the create process. If for
any reason you want to stop the build process and return to the
Main menu, press Esc. You may continue the build process by
selecting the Rebuild function later.
Note: You might not be able to use the array if the build has
not been entirely completed.
To add a spare to an existing RAID 1 array, see
Drive on page

Creating RAID 10 Arrays

To create a RAID 10 array:
1 From the Select RAID Type menu, select RAID-10 and press
Enter.
2 Select the hard drives you want to use and press Enter.
3 Select the stripe size and press Enter. You can select from 16K,
32K, or 64K.
Using the SCSISelect Utility to Manage Arrays
4-11.
Adding a Spare
4-9