Table of Contents
Advertisement
I
NSTALLING THE
D
D
EVICE
RIVER
Installing the Driver When Installing Windows NT 4.0
The Adaptec Fibre Card 9210LP driver is not embedded on the
Windows NT 4.0 installation disks (or CD-ROM) and must be
added during Windows NT installation. See your operating
system documentation for instructions.
N
OTE
attached to the Adaptec Fibre Card 9210LP, the Adaptec Fibre
Card 9210LP must be connected to a drive without a Fibre
Channel switch attached.
Completing a Fresh Windows NT 4.0 Installation
From Floppy Disk
Start your system with the Windows NT 4.0 Boot Disk in the
S
1
TEP
floppy disk drive.
When prompted, insert disk #2 into your floppy disk drive. After
S
2
TEP
a few moments you will see a blue screen. To set up Windows NT
now, press Enter.
Press S to skip auto-detection of devices in your system.
S
3
TEP
Press S again to specify an additional device.
S
4
TEP
Press Enter to select Others; insert the Adaptec Fibre Channel
S
5
TEP
Drivers disk in your floppy disk drive.
Using the arrow keys, select the following driver and press Enter:
S
6
TEP
Adaptec 1Gb/2Gb Family PCI Fibre Channel Controller
(NT 4.0)
A
DAPTEC
F
W
OR
In order to boot the operating system from a drive
Adaptec Fibre Card 9210LP
F
C
IBRE
NT 4.0
INDOWS
9210LP
ARD
9
Advertisement
Table of Contents
