Installing The Driver When Windows 2000 Is Already Installed - Adaptec AAA-UDMA Install Manual

Installing the Driver When Windows 2000 is Already
Installed
To update or install the cdaudma.sys driver if Windows 2000 is
already installed, follow these steps:
1
Start Windows 2000.
2
Click the Start button on the Windows 2000 task bar, and then
point to Settings.
3
Click the Control Panel.
4
Double-click the Add/Remove Hardware icon.
5
Click on the Next button on the Welcome to Add/Remove
Hardware screen.
6
Select Add/Troubleshoot a device, and then click on the Next
button.
7
This screen has a list of devices which are already installed.
Select Add a new device, and click on the Next button.
8
Next, select NO, I want to select the hardware from a list, and
click on the Next button.
9
This screen has a list of hardware device types. Select SCSI
and RAID controllers, and click on the Next button.
10
This screen has a list of manufacturers and their hardware
device models. Select the Have Disk button. You will be
prompted to insert the manufacturer supplied disk. Insert the
Windows 2000 Driver Disk for AAA-UDMA in your floppy
disk drive, and click on the OK button.
11
Select the Adaptec Array1000UDMA Family Manager Set for
Windows 2000 driver from the list, and click on the Next
button.
12
Click on the Next button again to confirm the installation of
the driver. You may be prompted with a warning message that
"The software you are about to install does not contain a
Microsoft Digital Signature ...". Ignore the warning and click on
the Yes button to continue the installation.
Installing the Software Driver for Windows 2000
5-5