Using Windows Nt 4.0 And The Host Adapter; Removing A Host Adapter - Adaptec 29320A-R Manual

Adaptec Ultra320 SCSI Cards User's Guide
Note: The file
the NT Registry, including the driver-specific registry value
/HOTPLUG
driver-specific registry values located at:
\HKEY_LOCAL_MACHINE\System\CurrentControlSet\
Services\adpu320\Parameters\Device\DriverParameters
If you have previously added other driver specific registry
values, you should note them before running the
file. After running
those previously added driver-specific registry values, if
needed.

Using Windows NT 4.0 and the Host Adapter

This section contains useful information on using Windows NT 4.0
and your host adapter.

Removing a Host Adapter

Note: In order to add or remove SCSI controllers from
Windows NT you must be logged on as Administrator.
Removing a host adapter can be as simple as physically removing
it from the slot when your computer is shut down.
Windows NT 4.0 starts and functions properly in this
configuration, but a Warning message is generated every time you
start Windows NT 4.0.
!
Caution: If you have removed a host adapter but still have
other host adapters of the same type installed in your
computer, do not use Windows NT 4.0 Setup to remove the
device driver.
9-6
adds Hot-Plug related entries into
hotp320.reg
. Running
hotp320.reg
hotp320.reg
will overwrite your current
, you may verify and restore
hotp320.reg