Adaptec 29320A-R Manual page 108

Adaptec Ultra320 SCSI Cards User's Guide
If the error message persists
a Restart your computer system to a DOS prompt again and
copy the current versions of
%systemroot%\system32\
b Once you've completed this process, remove the floppy disk
from drive
Option 2
1 Make a backup copy of disk 3 of the Windows NT 4.0 floppy
disk installer set.
2 Copy these files from the Current Driver Set:
DISK1
TXTSETUP.OEM
ADPU320.SYS
OEMSETUP.INF
3 Use the floppy installer set to begin the express setup and then
specify other when asked for type of mass storage controller.
The new
OEMSETUP.INF
allow you to complete the installation.
Option 3
This option assumes you are doing a fresh installation of
Windows NT 4.0.
1 Make a Bootable DOS partition on your hard disk drive using
Microsoft
fdisk.exe
partition with Microsoft
2 Restart your computer system to a DOS prompt and make a
directory in the
3 Copy all of the contents of the
Windows NT 4.0 CD into the
4 Copy the files,
OEMSETUP .INF
into the
I386
5 Restart the computer (make sure there are no floppy disks or
CDs in the computer).
9-10
drivers directory.
and restart your system.
A
should detect your controller and
2 GB or less in size and then format the
format.com
drive called
C
TXTSETUP.OEM
, from the Ultra320 Family Manager Set (FMS)
directory on your
into the
adpu320.sys
.
.
I386
subdirectory on the
I386
you created on the
I386
,
ADPU320.SYS
drive.
C
drive.
C
and