Completing A Fresh Windows Nt 4.0 Installation From Cd - Adaptec 29320A-R Manual

8 To add other host adapters that are not part of the Ultra320
Family, press S and repeat from Step 5 for each additional
adapter and insert the appropriate driver disk. The Adaptec
Ultra320 Family host adapters use the same driver; it is not
necessary to install the driver again.
9 Press Enter to continue with the Windows NT 4.0 operating
system setup. Follow the instructions on-screen and in the
Windows NT 4.0 documentation to complete the installation.

Completing a Fresh Windows NT 4.0 Installation From CD

1 Insert the Windows NT 4.0 CD into the CD-ROM drive.
2 Start your system. Press the F6 key when you see the following
message:
Setup is inspecting your computer's hardware configuration...
If you do not see this message, your system may not be setup to
boot from a CD. You will need to install from floppy disks. See
Completing a Fresh Windows NT 4.0 Installation From Floppy Disk
on page 9-2.
3 When prompted, press S to specify an additional device.
4 Press Enter to select Others; insert the Ultra320 disk for
Windows in your floppy disk drive.
5 Using the arrow keys, select the following driver and press
Enter:
Adaptec Ultra320 Family PCI SCSI Controller (NT4.0)
6 To add other host adapters that are not part of Ultra320 Family,
press S and repeat from Step 4 for each additional adapter and
insert the appropriate driver disk. The Adaptec Ultra320 Family
host adapters use the same driver; it is not necessary to install
the driver again.
7 Press Enter to continue with the Windows NT 4.0 operating
system setup. Follow the instructions on-screen and in the
Windows NT 4.0 documentation to complete the installation.
Installing the SCSI Driver for Windows NT 4.0
9-3