Installing The Driver When Windows 95/98 Is Already Installed - Adaptec P2280A Manual

Ultra160 Family Manager Set User's Guide
Installing the Driver When Windows 95/98 is
Already Installed
To update or install the adpu160m.mpd driver if Windows 95/98 is
already installed, follow these instructions:
Note:
All Adaptec Ultra160 Family host adapters use the
adpu160m.mpd driver. Once the correct driver is updated, it
is not necessary to update it again for each Ultra160 Family
host adapter installed in your system.
1
Start Windows 95/98.
2
Using the right mouse button (right-click), click the My
Computer icon.
3
Click Properties.
4
On the Device Manager tab, click the plus sign (+) next to the
SCSI Controller icon.
Caution:
If Windows 95/98 cannot determine the type
!
of host adapter installed in your computer, a yellow
question mark labeled Other Devices appears instead
of the SCSI Controller icon. To continue, click the plus
sign (+) next to the question mark; a yellow question
mark labeled PCI SCSI Bus Controller then appears.
5
Double-click the Ultra160 Family host adapter you wish to
update, or if a yellow question mark labeled PCI SCSI Bus
Controller is displayed, double-click the question mark.
6
Insert the Ultra160 Family Manager Set disk for Windows into
drive A.
7
Select the Drivers tab.
Caution:
If the version of Windows 95/98 you are
!
using displays an Update Driver button instead of a
Change Driver button, follow the procedures in the
section Updating the Driver for Windows 95 on page 3-7.
3-6