Adaptec 29320A-R Manual page 63

4 From the Options menu, select Configure/View SCSI
Controller Settings and press Enter.
Would you like to configure the SCSI controller, configure
HostRAID settings, or run the SCSI disk utilities? Select
the option and press <Enter>.
<Arrows> move cursor, <Enter> accept option, <Esc> exit (*=default)
5 From the Configuration menu, select HostRAID and press
Enter.
Configuration
SCSI Bus Interface Definitions
SCSI Controller ID ........................................ 7........
SCSI Controller Parity ....................................Enabled
SCSI Controller Termination ...........................Automatic
Additional Options
Boot Device Configuration.............................. Press <Enter>
SCSI Device Configuration .............................Press <Enter>
Advanced Configuration Options .....................Press <Enter>
HostRAID.......................................................Disabled
BIOS Information
Interrupt (IRQ) Channel.................................10
I/O Port Address............................................FC00h, F000h
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit ( * =default)
6 From the HostRAID Pop-Up menu, select Enabled.
Note: For information on Configuring SCSI Controller
Settings or using SCSI Disk Utilities, see the SCSI
controller hardware documentation.
Adaptec SCSISelect(TM)
39320A at slot 6, 00:0E:00
Configure/View SCSI Controller Settings
SCSI Disk Utilities
Adaptec SCSISelect(TM)
39320A at slot 6, 00:0E:00
<F6> - Reset to SCSI Controller Defaults
Using the SCSISelect Utility to Manage Arrays
Utility vX.XX
Options
Utility vX.XX
4-3