Error Messages - Adaptec 29320A-R Manual

6 At the DOS prompt do a change directory to
7 Once you are in the
This should begin a floppy-less installation of Windows NT 4.0.
The installation process should be able to find the SCSI
controller since the
your SCSI card.
The system is hanging and I can't copy files.
All of Intel's Pentium Processors require adequate heat sinks and
ventilation. If the processor is running excessively hot, this can
cause problems when installing Windows NT 4.0 (such as hanging
or not being able to copy files). Make sure you have an adequately
sized heat sink and good ventilation. If you're overclocking your
processor, then set it back to the manufacturers default clock
speed.

Error Messages

Error messages generated by the
by opening the Windows NT 4.0 Event Viewer error logs. For more
information on these Error Messages, see
Error Messages.
Installing the SCSI Driver for Windows NT 4.0
directory, type WinNT /B.
I386
OEMSETUP.INF
adpu320.sys
.
I386
and drivers are current for
driver can be viewed
Appendix B, Windows
9-11