Adaptec 29320A-R Manual page 135

Adaptec Ultra320 SCSI Cards User's Guide
[xxxxx041] Command aborted
[xxxxx042] Command aborted
[xxxxx043] Command aborted
[xxxxx044] Command aborted
[xxxxx045] Command aborted
An internal condition caused the driver to abort the command. In
most cases, the command is retried and is recovered, and normal
operation continues.
[xxxxx046] Target device did not respond to abort sequence
The target device did not abort the command requested by the
driver. Some devices do not support the abort command properly.
Normally, this indicates a faulty or noncompliant target device.
[xxxxx047] Command aborted
An internal condition caused the driver to abort the command. In
most cases, the command is retried and is recovered, and normal
operation continues.
[xxxxx048] Unable to abort command
An error occurred while aborting a command. Possibly, the
command has already completed and there is nothing to abort.
[xxxxx049] Command abort in progress
This indicates an abort command has been issued. This is a normal
operating condition.
[xxxxx051] Target device did not respond to reset sequence
The target device did not reset correctly as requested by the driver.
Normally, this indicates a faulty or noncompliant target device.
[xxxxx081] Adapter initialization failure
An error has occurred while the driver was setting up its internal
data structures. Verify that your adapter is supported by this
version of the driver.
[xxxxx083] Adapter not supported by this version of the driver
Your adapter is not supported by the driver on your system. You
may have installed a new adapter and have not updated the driver
on your system.
11-14