Modify The New System File; Rebuild The Unixware/Open Unix Kernel - Adaptec 29320A-R Manual

Adaptec Ultra320 SCSI Cards User's Guide
4 Type mail and press Enter. The mail messages tell you if the
installation was successful.
If a mail message informs you that the installation has failed,
turn to Troubleshooting on page
5 Type pkginfo -l adpu320 and press Enter.
6 Verify that the
If the
adpu320
to Troubleshooting on page
The listing should be similar to
PKGINST: adpu320
NAME: Ultra320 Driver for UnixWare 7.1.1

Modify the New System File

1 Display the contents of the UnixWare/Open Unix file by typing
the following and pressing Enter:
cat /etc/conf/sdevice.d/adpu320
2 If your computer is to boot from a device connected to a Ultra320
host adapter, verify that the line
below the line
3 If your computer is not to boot from the host adapter SCSI bus,
and you wish to leave the driver as a loadable module, edit and
verify that the line
.
$version 2

Rebuild the UnixWare/Open Unix Kernel

To rebuild the UnixWare/Open Unix kernel with the new changes:
1 Type the following at the # prompt and press Enter after each
line:
cd /etc/conf/bin
./idbuild -B
Status messages appear.
11-6
driver is now listed.
adpu320
driver does not appear in the pkginfo listing, turn
11-11.
.
$version 2
is not present directly below the line
$static
11-11.
is present immediately
$static