Disabling Hostraid Support - Adaptec 29320A-R Manual

Disabling HostRAID Support

After installing the HostRAID driver, you must disable HostRAID
support before you can use the standalone SCSI features.
Warning: Before you disable HostRAID, for RAID 1, you must
break a RAID 1 array. See the following steps for instructions.
For RAID 0, you will loose all your data if you try to disable
HostRAID.
To disable HostRAID, follow these steps:
1 Press Ctrl+A keys simultaneously when the Adaptec BIOS
appears.
2 When your SCSI Card appears, press Enter.
If you are using a dual channel card, select Channel A, then
press Enter.
3 On any channel containing an array, scroll down and select
Configure/View HostRAID Settings.
4 Select the array by scrolling to it and pressing Enter. This will
display the members of that array.
5 Press the key to delete the selected array. When prompted to
D
confirm deletion of the array, select Yes.
6 At the Deleting Information window, select None and press
Enter.
7 When prompted, select Yes to continue.
8 Repeat Steps 4 through 7 if there is another array. You will also
need to delete any spares.
9 Once all the arrays and spares have been deleted, press Esc to
go back to the SCSISelect menu.
10 Use the arrow keys to select Configure/View SCSI Controller
and press Enter.
11 From the Configuration menu, select HostRAID and press
Enter.
12 From the HostRAID Pop-up menu, select Disabled.
Migrating from HostRAID to Adaptec Ultra320 SCSI
F-9