Supported Raid Levels - Adaptec 29320A-R Manual

Supported RAID Levels

HostRAID includes a BIOS Configuration Utility for boosting disk
performance and data protection. Adaptec SCSI Card supports the
following RAID levels:
RAID 0, Striping—Two or more drives that can read and write
data in parallel. Offers higher performance than a single drive,
but no fault tolerance. RAID 0 arrays do not store redundant
data; if any disk in the array fails, all data is lost.
RAID 1, Mirroring—Data is mirrored on one pair of disks
providing 100 percent redundancy. Offers complete fault
tolerance. If one disk fails, data is still available. Increases read
performance through load balancing. Adaptec recommends
using the same size disks, but if you use a disk with less disk
space, the actual data capacity of the array equals the smaller
capacity disk.
RAID 10, Mirrored Striping—It is a striped array whose
members are mirrored arrays. RAID 10 provides both high
performance and fault tolerance.
Introduction
1-11