Table of Contents
Advertisement
Installing the Driver for a Boot Controller in a New
NetWare 4.11 Server
In this scenario, you are installing an Adaptec RAID controller as a
boot controller in a new NetWare 4.11 server with other hardware.
Note: Part of this procedure requires that you have enough
free space on your
NetWare CD.
To install the driver
1
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive and a
blank floppy disk in the floppy disk drive.
b
Copy all the files in
floppy disk.
c
Remove the Adaptec RAID Installation CD and the driver
floppy disk.
2
Install and configure your Adaptec RAID controller and hard
drives according to the instructions in
the Adaptec RAID controller is the primary controller. If other
controllers are present, install the Adaptec RAID boot
controller in a lower-numbered PCI slot than the other
controllers.
3
Install and configure a secondary controller, if any.
4
Start up the server. During restart, press Ctrl+A to start SMOR.
Use SMOR to create the RAID. For details, refer to
SMOR on page
5
Create a 750-MB DOS partition on the Logical Storage Unit
(LSU), which can be a drive or array group, with the lowest
LSU ID.
6
Boot the server to DOS from the partition you created in
Verify that you load the required CD drivers.
7
Insert the NetWare 4.11 CD.
drive to hold the contents of the
C
\packages\netware\4.11\driver
2-10.
Installing the Driver
to the
Chapter
2. Verify that
Using
Step
5.
3-19
Advertisement
Table of Contents
