Troubleshooting; No Remote Access To The R&S Tsma6 Via Lan Port - R&S TSMA6 User Manual

®
R&S TSMA6

8 Troubleshooting

8.1 No Remote Access to the R&S TSMA6 via LAN Port
If the R&S TSMA6 could not be accessed for remote control or remote desktop session
via the LAN port, check following issues:
Optical Check
► Check on the rear panel, if the LAN cable is connected to the correct LAN port (see
connector (12) in
The SCAN port has the fix IP address 102.168.3.1.
If the LAN cable is connected to the LAN port, continue with
the
Verify LAN Settings in the Web-GUI
1. Connect a mouse, keyboard, and a monitor and try to open the Web-GUI (see
Local access from the TSMA6 and Windows
The predefined start page is http://localhost.
Note: If the Web-GUI cannot be started local, contact the R&S support.
2. Check if an IP address is displayed in the Web-GUI. Does this IP address match
with the IP settings of the remote PC (IP subnet range)?
See
If no Remote Port address is displayed, continue with
Connections.
User Manual 4900.8057.02 ─ 01
Figure 3-2. This LAN port is set to "DHCP".
Web-GUI.
Figure 8-1.
No Remote Access to the R&S TSMA6 via LAN Port
Explorer).
Troubleshooting
Verify LAN Settings in
Check R&S TSMA6 Network
60