Periodic Maintenance; Removing Glass Particle Waste - Siemens ADVIA 2120 Operator's Manual

Periodic Maintenance

To ensure the operating efficiency of your Autoslide, be sure to follow the simple
maintenance procedures scheduled below:
Weekly
•
Clean glass particle waste
•
Clean the stain overflow tray
•
Perform Weekly shutdown and startup
After processing 3000 Slides
•
Clean the stainer wells and plate
•
Clean the power supply fan filter
As Needed
•
Replace the smearing tape and cleaning the smearing wedge
•
Replace the printer ribbon

Removing glass particle waste

Small particles of glass may be chipped off the slides during transfer from the
slide dispenser to the slide carrier. These particles are collected in a tray beneath
the slide dispenser.
To remove glass particle waste
Use caution when handling or troubleshooting objects with sharp edges. The
edges may cut and cause injury.
1. Using both hands, carefully pull the tray beneath the slide dispenser toward
you and remove it.
ADVIA Autoslide Slide Maker Stainer
WARNING
10-37