Siemens ADVIA 2120 Operator's Manual page 17

Start/Stop Sampler –
mode or stops the autosampler. When the autosampler operation is stopped,
samples underway are allowed to finish.
Eject Rack –
analysis of the last sample aspirated is completed.
Rack in Sampler –
including the input queue.
Off –
the touchpad.
Touchscreen
The touchscreen monitor makes it possible for you to perform your daily tasks
directly at the monitor without using the keyboard.
On the touchscreen monitor, you can do the following:
•
•
NOTE:
wet.
You can clean the touchscreen monitor using a lint free paper towel dampened
with 5% bleach solution. Dry the screen and your hands throroughly.
Manual Barcode reader
The manual barcode reader is used to enter information from labels on sample
tubes, reagent containers, controls, and calibrators. As each label is correctly
read, the LED on the wand will blink.
Welcome to the ADVIA 2120/2120i Hematology System
Starts the autosampler operation from the Ready to Run
Moves all racks within the autosampler into the output queue. The
Lights up when a sample rack is in the autosampler,
Turns off the power to all analyzer assemblies and power supplies, except
Use your finger, with or without gloves, to select all window controls,
including function buttons and operations in the online Help.
Move a window by holding your finger on the title bar of the window,
drag the window to the new location.
The touchscreen may not responds correctly if your finger or gloves are
1-13