Siemens ADVIA 2120 Operator's Manual page 252

Possible Cause
1 RBC Sheath
syringe pump
not moving or
not in home
position.
2 RBC Sheath
syringe
incorrectly
assembled.
3 Faulty power
supply, fuse,
cable, pump
assembly, Can
Bus Scrambler
Board or Dual
Servo Pump
Control Board.
Ready to Run
The system is ready to accept the aspiration of a sample or the start of a hydraulic
cycle. The green ready-to-aspirate light is lit.
Results Received for Tube Not in
Pending File Sid#: xxx Seq#: A set of results has been received for a sample that
is not in the Pending file. The set of results has been refused and deleted.
Corrective Action
Check pending list before run.
Status Line messages
Corrective Action
a Reset the analyzer by selecting
Exerciser, Indicators, Analyzer Reset
b After about 1 minute, if the status line
does not display Ready to Run and the
green ready-to-aspirate light is still off,
follow these steps to exit the ADVIA
2120/2120i software, turn off the analyzer
and then restart.
i Select
Shut Down ADVIA
On/Off window.
ii Select Off at the analyzer touchpad.
iii Select
CTRL+ALT+DELETE
back onto the system to restart the
software.
iv Restart the analyzer by selecting
the analyzer touchpad.
Follow the steps in Replacing the Syringe
Plungers.
Call Siemens Service for assistance.
Utilities,
.
at the Log
and log
On at
7-83