Maintenance Instructions; General; Replacing Damaged Or Missing Screws; Cleaning - Siemens MULTIMOBIL 2.5 Service Manual

8 Maintenance Instructions

8.1

General

All parts, modules of this product must be tested, inspected, for performance and
safety aspects every 12 months to ensure that the product functions properly and is
safe for patients, operating personnal and other persons.
Every 12 months, trained technical personnel should inspect and if necessary replace
system components of the generator which may produce hazardous conditions due to
excessive wear and tear. These instructions should be included in the annual
maintenance performed by Siemens Customer Service.
If more frequent inspections and maintenance are required by federal or local
regulations, ensure compliance with them.
8.2

Replacing damaged or missing screws

Before working on the open MULTIMOBIL 2.5 switch off the unit with the power switch
on the control panel and unplug the power cable.
Before inserting or removing PC boards, observe the ESD regulations.
Damaged or missing screws should only be replaced by steel screws having the
specified tensile strength with Nickel Plating (6492) specified in the Surface Finish
Documents.
8.3

Cleaning

The unit must always be switched OFF or disconnected before cleaning.
Use only water or a luke warm mixture of a household cleaner diluted with water to
clean the unit .
Do not use an abrasive or organic solvents or cleaning agents containing solvents
such as gasoline used for cleaning purposes, alcohol or stain remover . Do not spray
water on the unit.
CAUTION
Clean the unit with a damp cloth or cotton pad.
Dampen the cloth or pad with water or lukewarm, diluted commercially available liquid
cleaning solution.
Siemens Ltd. Med India
Switch OFF the system prior to cleaning,disinfecting, or
sterilizing
Version 6.0
Copyright © SIEMENS LTD. All rights reserved. For internal use only
Service Manual
Maintenance Instructions
8-3