Centering Of The Roll Holder - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Centering of the Roll Holder
Model JV300-130/160 Issued 2014.05.30 Revised

4.3.7 Centering of the Roll Holder

 Outline
Carry out centering so that the axes of roller holder (axis of both feeding side and take-up side) are aligned, by
positioning them face-to-face.
Good example: The axes of the roller holder
are in alignment.
 Adjustment procedure
Loosen
Loosen
© 2014 MIMAKI ENGINEERING CO.,LTD.
F/W ver. 1.00
Bad example: The axes of the right or left side of the
roller holder are out of alignment.
1. Carry out centering so that the axes of roll holder are aligned by
positioning the feeding side and the take-up side face-to-face.
2. In case their axes are not aligned, make adjustment after
loosening the screws of the bushing.
3. After the both axes have been aligned, tighten up screws and
check for any misalignment of axis at the right, left and central
part of the main body.
Remark
4.3.7
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0 P.1