Adjustment Of The Carriage Slant; Height For Right And Left - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Carriage Slant
Model JV300-130/160 Issued 2014.05.30 Revised

4.3.1 Adjustment of the Carriage Slant

 Outline
Perform carriage vertical-tilt and slant adjustment for right and left directions.
 Procedures
 Preparations
Head height adjust lever
 Height for right and left (slant for right and left) adjustment
Adjusting screws x4
Thickness gauge x4
Adjusting screw
x4
© 2014 MIMAKI ENGINEERING CO.,LTD.
F/W ver. 1.00
1. Move the carriage onto the platen.(The position of the second
clamp from the right is recommended.)
2. Move the Head height adjust lever to the lowest position.
3. Move the clamp lever downward.
Be sure to perform adjustment with the clamp lever
down. In addition, the head initialization height shall
be L range setting.
4. Remove the cutter unit. (Refer to
5. Loosen the adjusting screws (4 places of both sides).
6. Put the thickness gauge between the head mask plate and the
platen.(Refer to left figure.)
Fix the carriage by pushing it down and tightening adjusting
screws (x4).
Remark
6.2.11 Cutter Unit)
4.3.1
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0 P.1