Errors Related To The Amount Of Remaining Ink - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Operating Principle > Ink System > Ink System Error Monitoring
Model JV300-130/160 Issued 2014.05.30 Revised
1.3.2 Ink System Error Monitoring
 Errors related to the amount of remaining ink
 Calculate the number of ink shots by printing and flushing or the amount of ink sucked by cleaning and filling,
and then the amount of consumed ink by subtraction of remaining ink.
 When the amount of remaining ink is updated, it is written into the ink IC chip.
 A cartridge error is issued according to the amount of remaining ink.
No. Item
1 Cartridge near end
2 Cartridge ink end
3 INK REMAIN ZERO
(Only for the 4-color ink set)
4 WRONG CARTRIDGE
© 2014 MIMAKI ENGINEERING CO.,LTD.
Error detect timing
The amount of remaining ink is detected on the near
end detect PCB assy. The specified value of each
cartridge is as follows:
 220 cc cartridge: 20 cc
 440 cc cartridge: 40 cc
Displayed when use of a certain amount of ink is
detected after the near end detection.
 Displayed when the amount of remaining ink is
detected to be 0 cc after the ink end detection.
 This error may be displayed only after
completion of ink use-up cleaning.
Occurs when the amount of consumed ink exceeds
nearly double (220 cc cartridge: 400 cc, 440
cartridge: 800 cc or more) the ink cartridge capacity
but the ink end is not displayed yet.
F/W ver. 1.10 Remark
Description
Limitations after error detection
Initial filling is not allowed
Printing is allowed.
Cleaning is not allowed (only use-up
cleaning is allowed).
Neither printing nor initial filling is
allowed, but cleaning is allowed.
None of printing, initial filling and
cleaning is allowed.
None of printing, initial filling and
cleaning is allowed.
Rev.
1.0
1
2
3
4
5
6
7
8
1.3.2 P.2
R.1.0