Table of Contents
Advertisement
Setting the medium on the device
The medium that can be used with the device are roll medium and leaf medium.
Use the medium commended by MIMAKI.
• If a transparent medium is set, the following message appears on the LCD
and the medium may not be detected.
• If the medium is exposed to direct sunshine, the medium width may not be
detected correctly.
• Do not use printed media, or ink adheres to a pinch roller and media may
not be detected.
• Strong or internal curled media must be set to be along the platen by rolling
it in the opposite direction.
Setting a roll holder
• Attach the roll holder with two people.
The attachment position (height) of the roll holder can be set in three steps.
Depending on the medium, change the attachment position of the roll holder by reducing or increas-
ing the heater contact time.
To reduce the heater contact time, attach the roll holder at the top position ; to increase the heater
contact time, attach it at the bottom position.
When it is attached to the top or bottom position, it is necessary to use the lock pin to set the me-
dium.
page 2.14
1. Remove the four screws, and then remove roll
assy.
ERROR 50
MEDIA SENSE
- 2.8 -
Advertisement
Table of Contents
