Replacement Of The Wiper Unit - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Workflow > Ink Related Parts > Replacement of the Wiper Unit
Model JV300-130/160 Issued 2014.05.30 Revised

3.1.3 Replacement of the Wiper Unit

 List of replacement procedures
Item
Covers  Removal of covers, etc.
1.
Wiper Unit  Removal of the wiper unit.
2.

Mounting of the wiper unit
3.
 Adjustment of wiper height
4.
Adjustment  Capping adjustment
5.

Check Cleaning operation
6.
Covers  Mounting of the covers.
7.
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
© 2014 MIMAKI ENGINEERING CO.,LTD.
Work operation
Remove the Front cover L, M.
Remove the wiper unit.
Mount the wiper unit.
 For replacment : SPA-0134 Wiper kit 33S
Make adjustment so that, while head height is set low, wiper
units are kept parallel and wiper is in contact with the tip of
the nozzle by 1.5 mm. Confirm that wiping operation is
possible even when the head height is set high.
Carry out [CAPPING] adjustment to confirm that each
center of the wiper and the head is aligned.
Check whether each assembly and adjustment has been
carried out properly by wiper cleaning operation.
Mount the covers that have been removed.
F/W ver. 1.00 Remark
Wiper Unit
Description
Check whether the wiper moves smoothly while the
clearance between the motor pedestal and the wiper drive
link is set at 0.5 mm.
Rev.
1.0
1
2
3
Ref.
4
6.1.1
6.3.6
6.3.6
4.3.8
5
4.3.4
6
4.2.6
7
6.1.1
8
3.1.3 R.1.0 P.1