Going And Returning Adjustment - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > DROP.POS
Model JV300-130/160 Issued 2014.05.30 Revised
4.2.3 DROP.POS
 Going and returning adjustment
#PRINT ADJUST
SELECT:BiDir
SiDir
ReDir
#PRINT ADJUST
BiDir:PRINT
Pattern drawing
Check if the displacement
is almost equal in the right,
the center and the left of the
drawn area.
540Std BiDir WF3
= 0.0
-50.0~50.0
© 2014 MIMAKI ENGINEERING CO.,LTD.
F/W ver. 1.00
12. Select "BiDir" on the [SELECT] display.
[] / [] : Switches
[ENTER] : Confirms (Next)
13. Press the [ENTER] key to draw the pattern.
[ENTER] : To start Pattern drawing
[] : To the compensation display
(Without drawing)
14. Check and compensate the patterns.
The reference lines are drawn in going, and then the adjustment
lines are drawn at the same Y-coordinate positions in returning.
The position where the lines above are overlapped on one
vertical line is specified as the correct dot position (H1A: M-
color fixed)
Confirm that the dots are on the same line.
* The adjusting procedure is the same although the drawing
pattern is different depending on mode.
[] / [] : Compensating value input (Measured value)
[ENTER] : Confirms
If the displacement is significantly different in the
right and left, other reasons are considered.
15. When compensated, draw and check the patterns again.
Repeat "Drawing -> Checking (Compensating)" until
any compensation is not required.
Remark
4.2.3
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0 P.3