Replacement Of The Cartridge Assy - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Workflow > Ink Related Parts > Replacement of the Cartridge Assy
Model JV300-130/160 Issued 2014.05.30 Revised

3.1.2 Replacement of the Cartridge Assy

 List of replacement procedures
Item

Covers Removal of covers, etc.
1.

Ink Ink discharge
2.
Cartridge  Removal of the joint.
3.
Assy
 Removal of the cartridge.
4.

Mounting of the cartridge.
5.
 Mounting of the joint.
6.
Check  Check on the sensors
7.

Ink Ink filling
8.
Covers  Mounting of the covers.
9.
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
© 2014 MIMAKI ENGINEERING CO.,LTD.
Cartridge Assy
Work operation
Remove the Cartridge cover and Cartridge rear cover.
Discharge ink by executing [#ADJUST] – [HEAD WASH].
Remove the joint from corresponding cartridge.
Take care not to spill ink.
Disconnect the cables of corresponding cartridges from the
connector to remove the cartridges.
Mount the cartridge.
Mount the joint which has been removed.
Check whether the Detector Assy. I/C, Y and ID Contact
PCB CN032 Assy. of corresponding cartridges function
normally, by conducting ink cartridge test.
It is preferable to conduct a check by actually using
cartridges.
Fill up the ink channels with ink.
Check for any nozzle outs by conducting a test plotting.
Mount the covers that have been removed.
F/W ver. 1.00 Remark
Description
Rev.
1.0
1
2
3
4
Ref.
6.1.1
4.2.8
5
6
5.1.2
7
6.1.1
8
3.1.2 R.1.0 P.1