Edge Adjust - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > EDGE ADJUST
Model JV300-130/160 Issued 2014.05.30 Revised

4.2.14 EDGE ADJUST

 Function
Adjust the width of the each dead space of the right and left ends of the media.
Enter the actual measurement from the media edge to the pattern to the adjustment value. If the unit was changed to
inch, adjust by converting it to inch.
Is used when the system parameter has been initialized or the (plot areas at both ends) are not in the right place.
15mm
 Procedure
FUNCTION
#ADJUST [ENT]
#ADJUST
EDGE ADJUST [ENT]
** PRINTING **
Pattern drawing
Media width
LEFT RIGHT
= 15.0mm =
© 2014 MIMAKI ENGINEERING CO.,LTD.
Media width
1. Select [#ADJUST] - [EDGE ADJUST].
2. Draw an adjustment pattern.
3. Check the adjustment pattern.
4. Enter the adjustment value.
For adjustment, input actual values obtained by measuring from
the edge of the media to the pattern.
15.0mm
Adjusting value: 0.0 to 40.0 mm (unit: 0.1 mm)
(Use the inside of pinch roller as a positive (+). The backlash of
the pinch roller may produce an error of approx. ± 0.5 mm.)
[] / []: Changes adjustment values.
F/W ver. 1.00 Remark
[]: Set adjust values of L and R to default
(25.0 mm).
[]: Execute media width detection to draw an
adjustment pattern.
[]: To the screen for adjustment (Without
drawing)
[END]: Cancellation of input
 The set value is saved in the system parameter No.2
R GRIP and No.3 L GRIP as "current parameter
value + (25 mm - input value)".
Rev.
1.0
1
15mm
2
3
4
5
6
7
8
4.2.14 R.1.0 P.1