Adjustment Of The Mounting Location For The Cutter - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Mounting Location for the Cutter
Model JV300-130/160 Issued 2014.05.30 Revised

4.3.2 Adjustment of the Mounting Location for the Cutter

 Function
Adjust the cutter location in the back-and-forth direction by moving the cutter unit back and forth while visually
checking the location.
 Procedure
Gap for cutting
© 2014 MIMAKI ENGINEERING CO.,LTD.
F/W ver. 1.00
Cutter Unit
1. Use the cutter unit screws (x2) to temporarily fix the unit.
Tighten the screws just enough to support the unit.
2. Push down the clamp lever.
Be sure to make the adjustment while the clamp lever
is lowered. The head initial height should be set in
the L range.
3. Align the front and back of the cutter unit. press the cutter blade
assy down to the platen surface gap for cutting and adjust it
until it fits, and then determine the front and back position of
the unit and fix it using the screws.
If the jig is not available, press the cutter blade assy
down to the platen surface and adjust it until it fits the
platen.
4. Move the head unit manually and push down the cutter blade
assy at each right, center and left end on the platen, to check
back-front positioning.
On rare occasions, the blade comes out of the slot
because of assembly errors or fluctuation in part
accuracies. In such a case, adjust again to the back-
front optimum position where the blade is always in
whole slot on the platen.
Remark
4.3.2
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0 P.1