Heater; Operation Procedures Of “Temp.”; Operation Procedures Of “Ssr” - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Test Items > Test Function > HEATER
Model JV300-130/160 Issued 2014.05.30 Revised

5.1.15 HEATER

 Function
Temperature tests of the media heater, ON/OFF test of heater are executed.
 Temperature is displayed with a unit selected in the [UNIT SETUP] of the [MACHINE SETUP] function.
 A/D conversion value is also displayed.
 Operation Procedures of "TEMP."
Purpose: Check that heater temperature control can operate normally.
Contents: The operation is same when the HEATER key is pressed in LOCAL. However, the changed value is not
saved.
Step Item
1 Temperature setting
2 Temperature display
 Operation Procedures of "SSR"
Purpose: Check the heater operation and the A/D value.
Contents: The ON heater temperature moves up. If it is left, it may exceed the upper limit of the setting value. Be
careful about it.
Step Item
1 ON/OFF setting
2 ON/OFF display
© 2014 MIMAKI ENGINEERING CO.,LTD.
Sets temperature of Pre, Print, and Post Heater to control the heater.
Set value (Celsius): OFF, 20 – 70 C (unit: 1C)
Set value (Fahrenheit): OFF, 68 – 122F (Because conversion is used, the unit is
not 1F)
[END]: Returns to temperature setting.
Description
Designates ON/OFF of Pre, Print and Post Heater.
The temperature of the heater you turned on will rise. Be aware that if
left alone, it may exceed the set upper limit.
[END]: Returns to setting screen.
F/W ver 1.00 Remark
Description
1.0
Remarks
Remarks
Temperature is not controlled.
5.1.15 R.1.0
Rev.
1
2
3
4
5
6
7
8
P.1