Initial Filling; Operation Sequence For Initial Filling - MIMAKI JV300-130 Maintenance Manual

MAINTENANCE MANUAL > Operating Principle > Ink System > Initial Filling
Model JV300-130/160 Issued 2014.05.30 Revised

1.3.9 Initial Filling

 Operation sequence for initial filling
The sequence of initial ink filling is shown below:
No. Item
1 Selection of ink type (ink type)
2 Selection of number of colors
(ink set)
3 Ink filling
If filling any other than the 4-color ink set when this unit is installed, you have to change the coupler
before initial filling.
© 2014 MIMAKI ENGINEERING CO.,LTD.
F/W ver.
Select a set value shown below.
Setting value: SS21, Sb53, BS3
Select a set value shown below.
Setting value:4-Color (MMCCYYKK),
6-Color (MMBlBlYLmKLc),
8-Color (MOrCLkYLmKLc),
6-Color+W (MWCWYLmKLc)
Insert the ink cartridges into all the slots and start ink filling.
When filling the 4-color ink set or M and Bl ink of the 6-color ink set:
1. Fill ink up to the coupler. Within the same supply system, open the carriage valves in
the order of even columns  odd columns, and fill the ink up to the coupler.
2. Fill ink up to the damper (head)
Except when filling the 4-color ink set:
1. Open all of the cartridge valves and fill the ink up to the damper (head).
• Filling will not be executed if a warning about the ink cartridge is displayed.
• When a waste ink tank warning occurs, the warning message is displayed.
• If a cartridge warning is displayed after completion of filling ink up to the coupler
and before completion of filling ink up to the damper (head), switching between
the cartridges will take place and filling will be continued.
(Only for filling the 4-color ink set)
Filling will be discontinued if one supply system becomes unable to supply ink.
2. When the 6-color +w ink set is used,
• Filling of the color inks is performed earlier, afterward filling of the W ink is
performed.
1.10 Remark
Description
Rev.
1.0
1
2
3
4
5
6
7
8
1.3.9 R.1.0 P.1