Page 3
1-9. Head and Adjusting Spring removed. If head is covered by warranty, fl ush, drain, place rubber cap over nozzles and package ready for return to Mimaki USA. 2. Installation of New Head: Important: Water-based transportation liquid (S-46), supplied in the head at the time of shipment, reacts to solvent ink and may cause clogging.
Page 5
K M C Y Lm Lc Adjusting flow Added from firmware vers i on 3. 10. ,- ------------------, Check which is high priority, • Head he i ght head high head lo w ? . Head speed. standerd or high speed? Select Select from LS, LH, HS, HH.
Page 6
( 1) Base PRN.adjust2 Adjustment PRN.adjust2 SEL. Y Base oattern orint Y Base Gl-2 : 0.0 Cl - 2, Cl - 3 , ���:: �g�) � � � 'p" � �!1 �! �� � _________ _ CD I nput the va I ue wi th !2S1 [S2] key, and set it with AI I colors ( not including black ) are adjusted to overlap straight on Head No.1 (Black) as standard.
Page 7
( 2 ) B i -D i rect i ona Sing Repeat. Adjustment # PRN.adjust2 # PRN.adjust2 Vl # PRN.adjust2 Vl oattern orint SEL. : Var i ab I e-l Adjust Si. Hl-2 : 0.0 ------------------------------------ ---- r---- : H l - 2. H l - 3 . :Var i able-2 :Norma l-l I n put va lue: -50-w50 (0.
FINE S i . (F I NE Re. and B i . Adjustment # PRN. adjust2 # PRN. adjust2 Vl # PRN. adjust2 Vl oattern orint SEL : Variable-l Y Si. Cl-2 : 0.0 Adjust :FINEYSi. : V ar i able-2 : Cl - 2.
Page 9
( 4 ) DIRECT I ON # PRN. adjust2 # PRN.adjust2 Adjustment DIRECTION DIR Hl-2 : 0.0 oattern orint H l - 2. H l - 3 . n put -50-50 ( 1 dot u n i t) --------------------------------------------- l2S] [2J G) Input the value with key.