Siemens SIMATIC RF300 System Manual page 48

Planning the RF300 system
4.1 Fundamentals of application planning
4.1.7 Operation in static and dynamic mode
Operation in static mode
If working in static mode, the transponder can be operated up to the limit distance (S
transponder must then be positioned exactly over the reader:
Figure 4-7
Operation in dynamic mode
When working in dynamic mode, the transponder moves past the reader. The transponder can
be used as soon as the intersection (SP) of the transponder enters the circle of the transmission
window. In dynamic mode, the operating distance (S
consequences, refer to the section "Field data for transponders, readers and antennas
(Page 49)".
Figure 4-8
4.1.8 Dwell time of the transponder
The dwell time is the time in which the transponder remains within the transmission window of
the reader. The reader can exchange data with the transponder during this time.
The dwell time is calculated as follows:
48
Operation in static mode
Operation in dynamic mode
) is of primary importance. For possible
a
System Manual, 02/2021, C79000-G8976-C345-09
). The
g
SIMATIC RF300