Siemens SIMATIC RF300 System Manual page 15

Introduction
1.1 Preface
Purpose of this document
This system manual contains all the information needed to plan and configure the system.
It is intended both for programming and testing/debugging personnel who commission the
system themselves and connect it with other units (automation systems, further programming
devices), as well as for service and maintenance personnel who install expansions or carry out
fault/error analyses.
Scope of validity of this document
This documentation is valid for all variants of the SIMATIC RF300 system and describes the
devices shipped as of 02/2021.
Additional information
You will find additional information on the devices listed in this manual and their configuration
and parameter assignment in the following manuals:
• Operating Instructions "Mobile reader RF350M"
• Compact operating instructions "SIMATIC RF310R Scan Mode"
• Compact operating instructions "SIMATIC RF382R Scan Mode"
• Function manual "Ident profile and Ident blocks, standard function for Ident systems"
• Function manual "FB 45 for MOBY U, MOBY D, RF200, RF300"
You will find the latest versions of these manuals on the pages of the Siemens Industry Online
Support (https://support.industry.siemens.com/cs/ww/en/ps/14971/man).
Detailed information on peer-to-peer communication (P2P), also referred to as reader-reader
communication, is available in the Product Information "P2P operation for the RF300 system
(https://support.industry.siemens.com/cs/ww/en/view/109749570)".
Registered trademarks
The following and possibly other names not identified by the registered trademark sign ® are
registered trademarks of Siemens AG:
SIMATIC ®, SIMATIC RF ® and MOBY ®
SIMATIC RF300
System Manual, 02/2021, C79000-G8976-C345-09
1
15