Siemens SIMATIC RF300 System Manual page 430

System diagnostics
10.2 Diagnostics functions - STEP 7
Name
field_ON_time_SLG
status_ant
MDS_control
430
Type Possible Value
(hex)
byte
0x00
0x01
0x03
0x04
0x05
0x06
0x07
0x08
0x10
0x20
0x2F
0x31
0x40
0x4F
0xFF
byte
0x01
0x02
byte
0x00
0x01
0x02
0x04
0x06
Comment
Selection of the transponder types used
= RF300 (RF3xxT)
= ISO 15693 general
= ISO 15693 (MDS D3xx; Infineon)
= ISO 15693 (MDS D4xx; Fujitsu - 2 kB)
= ISO 15693 (MDS D1xx; NXP)
= ISO 15693 (MDS D2xx; TI)
= ISO 15693 (MDS D261; STM)
= ISO 15693 (MDS D5xx; Fujitsu - 8 kB)
= RF300 (RF3xxT) 2)
= ISO 14443 (MIFARE Classic, MOBY E, MDS E6xx)
= ISO 14443 (MIFARE Classic, alternative key)
= General Mode
2)
= P2P master
2)
= P2P slave 2)
= Setting via "scanning_time" and "fcon"
Only valid with readers of the 2nd generation
2)
Status of the antenna
= Antenna is switched on
= Antenna is switched off
Presence check
= Operation without presence check
Antenna is permanently switched on.
= Operation with presence check
Antenna is permanently switched on.
= 2: Operation without presence check and with semaphore pro‐
cedure (RF300, ISO 14443 [MIFARE Classic])
Antenna is permanently switched on.
= Operation without presence check
Antenna is switched off. The antenna is only switched on when
one of the following commands is sent: Read, Write, Init, Tag-
Status
= Operation without presence check and with semaphore pro‐
cedure (RF300, ISO 14443 [MIFARE Classic])
Antenna is switched off. The antenna is only switched on when
one of the following commands is sent. Read, Write, Init, Tag-
Status
System Manual, 02/2021, C79000-G8976-C345-09
2)
2)
SIMATIC RF300