Rear Cover Installation - GE LOGIQ E9 Service Manual

GE
D 5573152-100, R
IRECTION
8-5-12-5

Rear Cover installation

1.) Position the lower edge of the Rear Cover into place on the rear of the system frame.
2.) Tilt the top edge of the Rear Cover toward the system frame.
Be sure the manual release handle of the Z Mechanism extends through the air vent on the Rear
Cover.
3.) Position the Rear Cover into place.
4.) Gently pull up on the Z Mechanism's manual release handle to confirm proper position through the
Rear Cover air vents.
5.) Install the four screws, two on each side.
6.) Inspect the Filter, and clean in necessary.
7.) Install the Filter.
8.) Install the Filter Cover
9.) Re-install the V Nav On-Board Stand if present.
. 2
EV
Figure 8-16 Z Mechanism manual release handle
Chapter 8 Replacement procedures
LOGIQ E9 S M
ERVICE ANUAL
8 - 53