GE LOGIQ E9 Service Manual page 495

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5573152-100, R

Table 8-131 BEP removal - R4.x and later

When you return the used BEP to your local parts organization, make sure you remove ALL

PATIENT DATA from the Hard Drive, given that the Hard Drive is still functional.

In some countries, you may be required to delete all software from the disk before returning the

BEP to the parts warehouse. Follow your local policies.

Before you dispose of the Hard Drive, make sure you remove ALL PATIENT DATA from the Hard

Drive, given that the Hard Drive is still functional.

In some countries, you may be required to delete all software from the disk before returning the

Hard Drive to the parts warehouse. Follow your local policies.

When the BEP door is open, the ChargeBoard is exposed. When working inside the BEP,

remove the battery cable from PCN1 on the ChargeBoard. Otherwise, the 24V battery will be

exposed. If you drop a tool or a screw on the Extended Power Shutdown or ChargeBoard, you

could short the battery. Permanent damage will be done if this happens.

You cannot power up the unit with the cables detached. The system will power up without the battery

pack, but the cables on the cover must be attached.

Some cables in the BEP have a locking latch. Make sure to slide the locking latch towards you and pull

the connector to the left to release.

Disconnect all I/O cables and all cables at the top of the BEP. See:

connectors - J5 PCIe to GFI2 is present on GFI Configuration" on page

Loosen the thumb screws or screws at the top of the BEP cover, or the three screws that attach

the cover to the BEP.

Tilt the top of the BEP cover away from the BEP.

Chapter 8 Replacement procedures

Corresponding Graphic

Figure 8-57 "BEP6 cable